Skip to content

nixie tubes

I finally received a batch of 1n-14 nixie tubes that I purchased from ebay for a future clock project. The tubes need a power supply that can supply 170 volts DC, which I didn’t have, so I built one.

I came across a few switching designs online and I settled on the one from here, mainly because I had most of the parts on hand. I made a few changes from the schematic which I’ll detail below.

My changes (based mostly on parts that I had available):

  • L1 = 150uH
  • D1 = BAV21
  • T1 = IRF610
  • RSENSE = 1 ohm
  • C4 = 10uF
  • C6 = 470nF
  • VR1 = 10k ohms

I built the circuit on a piece of perf board with screw terminals for the inputs/outputs.

It worked pretty well from the start. I was getting 181.5V DC during my first run.

From 3.6 volts in, I was getting the full voltage. I will run it on 12 volts during actual use. (Ignore the messy desk.)

I plugged one of the tubes into a breadboard and just hardwired the power supply to the anode through a resistor and one of the cathodes and tried it out.

It works!

Now, to give it some logic. I wired up an MPSA42 transistor for each cathode and connected them to a bcd to decimal converter. I then put together a quick arduino sketch to scroll through the numbers. It was a bit overkill, but its what I had laying on the desk at the time.

I just about ran out of jumper wires.

Well, the power supply seems to work and the tubes look okay. Next step is to design and build an actual clock.

 

Be First to Comment

Leave a Reply

Your email address will not be published. Required fields are marked *